Flow cell tubing/connector M6
The M-6 threaded connector micro scope slide holder
allows for the easy, secure connection of the flow cell into the pump/manifold plumbing of your system. The threading is standard metric M6 type which forms a tight seal when threaded into the top of the flow cell. The M6 connector holds a PTFE tube firmly in place which seals tightly against the internal quartz surface of the flow cell. Using this design, your sample comes in contact with PTFE and quartz only. The connection is further stabilized by the use of a stainless steel ring and neoprene o-ring assembly which keeps the PTFE tubing from deforming when tightened. Each connector is supplied with 40 cm of PTFE tubing. The dimensions of the supplied tubing is: 1.6mm OD, 0.8mm ID
Component Area Dimension
M6 Connector Total height, tall side 26 mm
M6 Connector Total height, short side 19 mm
M6 Connector Diameter 6 mm
PTFE tubing Outside diameter (OD) 1.6 mm
PTFE tubing Inside diameter (ID) 0.8 mm
PTFE tubing total length 400 mm